Monitoring The Clearance Control Status; Analog Monitors; Option Monitors With Mechatrolink-Iii Communications; Monitoring With Sigmawin+ Waveform Traces - YASKAWA SGD7S series Product Manual

Monitoring the Clearance Control Status

8.3

8.3.1 Analog Monitors

8.3

Monitoring the Clearance Control Status

You can monitor the following signals related to clearance control through analog monitors or
through MECHATROLINK-III communications option monitors.
8.3.1

Analog Monitors

Pn006
Pn007
8.3.2 Option Monitors with MECHATROLINK-III Communica-
tions
Pn824
Pn825
8.3.3

Monitoring with SigmaWin+ Waveform Traces

Clearance Offset Reference
Gap
8.3.4

Monitoring with SigmaWin+ I/O Tracing

Clearance Control Com-
mand Bit
Clearance Control Opera-
tion Bit
8-10
Parameter

n. 34
Clearance Offset Reference-Gap Deviation

n. 35 Gap
Parameter
Clearance Control Operation
004A hex
Monitor
004B hex Gap Monitor
Name
Signal
Clearance Control Command (Input)
(CLCCMD)
Clearance Control Operation (Output)
(CLCRUN)
Description
Signal
Bit 0 = 0: Clearance control operation
is disabled.
Bit 0 = 1: Clearance control operation
is enabled.
1 reference unit
Unit
1 reference unit
1 reference unit
Selected Data Name
Output Unit
0.05 V/Reference
unit
0.01 V/Reference
unit
Output Unit
Meaning
Low: Disable clearance control.
High: Enable clearance control.
Low: Clearance control operation is
disabled.
High: Clearance control operation is
enabled.