3.1 Basic Wiring Diagrams - YASKAWA SGD7S series Product Manual

*4.
Refer to the following manual if you use a safety function device.
Σ Σ
-7-Series -7S SERVOPACK with MECHATROLINK-III Communications References Product Manual (Manual No.: SIEP S800001
28)
If you do not use the safety function, insert the Safety Jumper Connector (provided as an accessory) into CN8 when you use the SERVO-
PACK.
*5.
Always use line receivers to receive the output signals.
Note: 1. You can use parameters to change the functions allocated to the /DEC, P-OT, N-OT, /EXT1, /EXT2, and /EXT3 input sig-
nals and the /SO1, /SO2, and /SO3 output signals. Refer to the following manual for details.
Σ Σ
-7-Series -7S SERVOPACK with MECHATROLINK-III Communications References Product Manual (Manual No.: SIEP
S800001 28)
2. If you use a 24-V brake, install a separate power supply for the 24-VDC power supply from other power supplies, such as
the one for the I/O signals of the CN1 connector. If the power supply is shared, the I/O signals may malfunction.
3. Default settings are given in parentheses.

3.1 Basic Wiring Diagrams

3
3-3