YASKAWA SGD7S series Product Manual page 252

10.1 List of Servo Parameters
10.1.2 List of Servo Parameters
Parameter
No.
Pn853
Pn860
*8
M3
10-42
Name
Latch Sequence 5 to 8
2
Settings
Latch Sequence 5 Signal Selection
0 Phase C

n. X 1 EXT1 signal
2 EXT2 signal
3 EXT3 signal
Latch Sequence 6 Signal Selection
 
n. X
The settings are the same as those for the Latch Sequence 5 Signal Selec-
0 to 3
tion.
Latch Sequence 7 Signal Selection
 
n. X
The settings are the same as those for the Latch Sequence 5 Signal Selec-
0 to 3
tion.
Latch Sequence 8 Signal Selection

n.X
The settings are the same as those for the Latch Sequence 5 Signal Selec-
0 to 3
tion.
SVCMD_IO Input Signal
2
Monitor Allocations 1
Input Signal Monitor Allocation for CN1-13 (SVCMD_IO)
0 Allocate bit 24 (IO_STS1) to CN1-13 input signal monitor.
1 Allocate bit 25 (IO_STS2) to CN1-13 input signal monitor.
2 Allocate bit 26 (IO_STS3) to CN1-13 input signal monitor.

n. X 3 Allocate bit 27 (IO_STS4) to CN1-13 input signal monitor.
4 Allocate bit 28 (IO_STS5) to CN1-13 input signal monitor.
5 Allocate bit 29 (IO_STS6) to CN1-13 input signal monitor.
6 Allocate bit 30 (IO_STS7) to CN1-13 input signal monitor.
7 Allocate bit 31 (IO_STS8) to CN1-13 input signal monitor.
CN1-13 Input Signal Monitor Enable/Disable Selection
 
n. X 0 Disable allocation for CN1-13 input signal monitor.
1 Enable allocation for CN1-13 input signal monitor.
Input Signal Monitor Allocation for CN1-7 (SVCMD_IO)
 
n. X
0 to 7 The settings are the same as the CN1-13 allocations.
CN1-7 Input Signal Monitor Enable/Disable Selection

n.X 0 Disable allocation for CN1-7 input signal monitor.
1 Enable allocation for CN1-7 input signal monitor.
Setting Setting Default
Range Unit Setting
0000 to
– 0000
3333
0000 to
– 0000
1717
Continued from previous page.
Applicable When Classi-
Motors Enabled fication
Immedi-
All Setup
ately
Immedi-
All Setup
ately
Continued on next page.
Refer-
ence
*2
*2