Table of Contents
Advertisement
Write the data.
4
When a confirmation message appears asking whether to write the data to the selected controller,
check the data name and the target controller, and click the [OK] button to start writing the data.
If you want to cancel writing the data, click the [Cancel] button.
Confirmation message
Check that the data has been written.
5
When the message appears stating the data writing has been completed, click the [OK] button.
The data will be usable after turning the control power off and then back it on again. (Restarting the
control power may not be necessary depending on the parameters to be written.)
"Writing completed" message
Click.
Click.
C
24C17-M0-00
24C18-M0-00
C-15
Advertisement
Chapters
Table of Contents
