Mounting/Removing The Option 3 Slot Adapter; Mounting Method - Toshiba TOSVERT VF-AS3 Instruction Manual

Important
10. 4. 3
Mounting/removing methods of the option 3 slot adapter are as follows.
Mounting and removing methods of a cassette option is the same with option slot A, B. For details, refer
to [10. 4. 2].

■ Mounting method

1 Remove the front covers and other parts in
advance.
Covers to be removed at the time of wiring vary
depending on the frame size.
For how to remove, refer to [2. 2].
2 While pressing the PUSH part located on both right
and left side of the operation panel, pull the opera-
tion panel straight upward.
The operation panel is connected to the unit with
the connector on the center of back side.
9
3 Remove the protection label.
10
4 Remove the option connector cover.
Store the removed parts so as not to be lost.
5 Remove the option wiring cover.
The option wiring cover can be removed by fingers.
Store the removed parts so as not to be lost.
10. Selection and installation of peripheral devices
• Do not use excessive force to press a cassette option to the option slot, or the connector pin
may be damaged. Along the guide, insert straight slowly.
• Depending on a cassette option, insertion to the option slot A, B may not be possible. Refer to
[10. 4. 1].
• In the case of frame size A7 or A8, remove the wire-holding fitting mounted at the lower part of
the option slot A, B before inserting/removing the cassette option.

Mounting/removing the option 3 slot adapter

Connector cover
10-16
E6582062
Operation panel
Protection label
Wiring cover