Toshiba TOSVERT VF-AS3 Instruction Manual page 124

4 Select "3.7. Panel parameter (F7--)" with the touch
wheel.
5 Press the [OK] key.
The top screen of the parameters is displayed,
starting with <F700: Parameter reading&writing
access lockout>.
4
6 With the [F3] key
<F710: Standard mode display>.
The [F3] key
displays five parameters at a time page by page.
The [F2] key
9
five parameters at a time page by page.
The number displayed at the right end of each item
is the current setting value.
7 Press the [OK] key.
The setting screen of <F710: Standard mode
display> is displayed.
The current setting value is highlighted, and a
check mark is displayed at the right end.
In the example on the right, "0: Output frequency"
is the current setting value.
4. [Basic operation] Operation methods of motor
and the touch wheel, select
scrolls down the screen that
scrolls up the screen that displays
4-16
E6582062
STOP 0.0Hz
Extended parameters (F ---)
Operation parameters (F3 - -)
3.3
Motor parameters 1 (F4 - -)
3.4
Acc/dec parameters (F5 - -)
3.5
Protection parameters (F6 - -)
3.6
Panel parameters (F7 - -)
3.7
Top
STOP 0.0Hz
Advanced pararneters (A ---)
: Parameter read & write lock
A700
: Current voltage units select
A701
: Free unit multiplying factor
A702
: Target of free unit
A703
: Free unit inclination polarity
A705
F6 --
STOP 0.0Hz
Extended parameters (F ---)
: Free unit bias
A706
: Step of panel setting
A707
: Step of panel display
A708
: Standard mode hold
A709
: Standard mode display
A710
F7 --
STOP 0.0Hz
A710 : Standard mode display
0: Output frequency
1: Frequency reference
2: Output current
3: DC Bus voltage
4: Output voltage
15:09
0
Monitor
16:08
0
0
0.00
0
1
F8 --
15:08
0.00Hz 0
0.00Hz
0
0
0
F8 --
15:08