Toshiba TOSVERT VF-AS3 Instruction Manual page 574

Trip
display
Err3
Err4
Err5
Err6
Err7
Err8
4
Err9
4
Etn
8
9
Etn1
Etn2
13
Etn3
EtyP
13. Trip information and measures
Failure
Trip name
code
0016 ROM fault Control ROM fault.
0017 CPU1 fault A Control CPU fault.
0018 Communication RS485 communication timed out.
time-out
(RS485)
0019 Gate array Fault in the gate array.
fault
001A Current Fault in the output current detector.
detector fault
001B Communication Communication option timed out.
time-out
(option)
001C Panel While running with a run command from
disconnection the operation panel and extension panel,
during run the cable connecting the inverter and
panel are disconnected.
0028 Auto-tuning 1) The motor parameter does not match
error the motor characteristic.
2) Executed auto-tuning while the motor is
rotating.
3) The output frequency does not increase
within few minutes.
0054 Auto-tuning 1) The motor is not connected.
error 1 2) Something other than the motor is
connected.
3) In the induction motor, an improper
value, a synchronized motor speed
value or a value close to it is set in
<F417: Motor rated speed>.
0055 Auto-tuning The motor parameter does not match the
error 2 motor characteristic.
0056 Auto-tuning The setting on <vL: Base frequency 1> or
error 3 <F417: Motor rated speed> does not
match the motor rating.
0029 Inverter type 1) Internal error exists.
error 2) Replaced the printed circuit board
(contact your Toshiba distributor for
replacing the printed circuit board).
*Enable/Disable can be selected for trip with a parameter.
Detection factor
Fault in internal inverter.
Contact your Toshiba distributor.
Fault in internal inverter.
Contact your Toshiba distributor.
Check the communication equipment and
wiring on RS485 communication.
Fault in internal inverter.
Contact your Toshiba distributor.
Fault in internal inverter.
Contact your Toshiba distributor.
Check the communication equipment and
wiring on communication option.
Check the connection on the inverter and
panel.
1) Set the motor parameters according to
<vL: Base frequency 1>,
<vLv: Base frequency voltage>,
<F405: Motor rated capacity>,
<F415: Motor rated current>,
<F417: Motor rated speed>, etc.
2) Check that the motor is stopped, and
3) Check that the motor is not stopped
1) and 2) Check that the motor is
3) Set <F417> according to the motor
Set the motor parameters according to the
motor characteristic.
<vL: Base frequency 1>,
<vLv: Base frequency voltage>,
<F405: Motor rated capacity>,
<F415: Motor rated current>,
<F417: Motor rated speed>, etc.
Set <vL: Base frequency 1> or <F417:
Motor rated speed> according to the
motor rating.
1) Error in internal inverter.
2) Set <tyP: Default setting> = "6: Initialize
13-4
E6582062
Measures
the motor characteristic.
perform auto-tuning again.
while the output frequency is risin on
the system.
connected.
rating.
Contact your Toshiba distributor.
typeform".