Toshiba TOSVERT VF-AS3 Instruction Manual page 129

5 Select "10: Touch wheel 1 (power off or press OK
to save)" and press the [OK] key.
The basic parameter screen is displayed.
Check that the setting value of <FMOd: Frequency
command select 1> is "10".
6 Press the [ESC] key or [F1] to [F4] keys to switch to the [Standard mode] screen.
7 In [Standard mode], press the [OK] key.
The setting screen of <FC: Panel run frequency> is
displayed.
If you leave this setting screen as it is, the screen
returns to the [Standard mode] screen for a few
seconds later.
8 Change the frequency command value with the
touch wheel.
When the setting value is changed, the value on
the lower side of the screen is highlighted.
In the example on the right, it is set to 30.0 Hz. This
becomes the frequency command value.
FMOd :Frequency command select 1
6: -
7: -
8: -
9: -
10: Touch wheel 1 (power off or press
: Run command select
CMOd
: Frequency command select 1
FMOd
: V/f Pattern
Pt
: Manual torque boost 1
vb
: Base frequency 1
vL
FC
Output frequency
Min: 0.0
X1000
FC
Output frequency
Min: 0.0
X1000
4-21
4. [Basic operation] Operation methods of motor
E6582062
STOP 0.0Hz
15:16
(
STOP 0.0Hz
15:17
Basic parameters
1
10
0
4.80%
60.0Hz
STOP 0.0Hz
15:53
:Panel run frequency
0.0Hz
20.0Hz
Max: 60.0
X100 X10 X1
STOP 0.0Hz
15:28
:Panel run frequency
0.0Hz
30.0Hz
Max: 60.0
X100 X10 X1
t
3
4
9