Toshiba TOSVERT VF-AS3 Instruction Manual page 142

The basic parameter screen is displayed.
Check that the setting value of <FMOd: Frequency
command select 1> is "1."
In this setting, the voltage signal input to the
terminal [RR] should be the frequency command.
Here, the voltage input to the terminal [RR] is
adjusted with the potentiometer.
12 Press the [ESC] key or [F1] to [F4] keys to switch
to the [Standard mode] screen.
In the main area of the [Standard mode] screen, the output frequency (0.0 Hz) is displayed.
13 Turn on the external switch.
4
14 When you rotate the potentiometer, the frequency
command value increases, and the motor starts
running.
The following are always displayed in the status
area on the upper side of the screen regardless of
display mode. (From the left)
• The
• Operation status "RUN"
• Output frequency (display contents vary
depending on the setting of the parameter)
9
• Run command icon
Memo
15 When you turn off the external switch, the motor decelerates and stops.
4. [Basic operation] Operation methods of motor
icon is rotating
• In some cases, for example, when the potentiometer is set to the maximum/minimum, you can
set the two frequency command points. The default setting is 0.0 Hz/60.0 Hz. For details, refer
to [7. 3. 2].
: Run command select
CMOd
: Frequency command select 1
FMOd
: V/f Pattern
Pt
: Manual torque boost 1
vb
: Base frequency 1
vL
MAX
MIN
Output frequency
60Hz
0
MIN
Easy
Easy
4-34
E6582062
STOP 0.0Hz
15:55
Basic parameters
0
1
0
4.80%
60.0Hz
PP
: Frequency settings
RR
by potentiometer
CC
MAX
RUN 60.0Hz
RUN 30.0Hz
20:52
16:14
Standard Mode
Top View Mode
60.0
60.0
Hz
Hz
Keypad Copy Monitor
Screen Copy Monitor