Charge Lamp - With Frame Size A1 To A5 - Toshiba TOSVERT VF-AS3 Instruction Manual

2 Remove two screws of the wiring duct.
Store the removed screws so as not to be lost.
3 Remove one nut.
Store the removed nut so as not to be lost.
4 Lift the left side of the wiring duct first and remove it from the
unit.
Be careful that the bolt from which the nut has been removed
does not get caught in the bolt hole.
5 Mount the wiring duct in the reverse procedure.
First, adjust the bolt hole to the position of the bolt.
Be sure to mount the wiring duct before the transparent cover.
2. 2. 5 Charge lamp
While the charge lamp is on (red), voltage is applied, or high voltage remains in the inverter.
The location of the charge lamp varies depending on the type.
■ With frame size A1 to A5
VFAS3-2004P to 2370P, VFAS3-4004PC to 4750PC
The charge lamp is inside the front cover.
In the case of frame size A1, check the charge lamp in the following procedure. Also for other mod-
els, remove the front cover by referring to [2. 2] and check the charge lamp.
1 Loosen four screws of the front cover.
Since the screws are of falling prevention type, they do
not come off the front cover even if loosened.
2-17
E6582062
Screw
Wiring duct
Nut
Wiring duct
Bolt hole
Front cover
2. Installation and wiring
2
3
9
10