Monitor Peak And Minimum Hold Trigger - Toshiba TOSVERT VF-AS3 Instruction Manual

When <F295: Bumpless> is set to "1: Enabled", the mode can be switched even during run.
In manual, the [EASY] key lamp or
In automatic, the inverter is operated with the operation method selected with <CMOd: Run
command select>, <FMOd: Frequency command select 1>, etc.
Auto
(Remote)
• Note that when you set <F750> to "0" in manual, the panel operation status remains and the
Memo
setting is different from the one with <CMOd: Run command select>.

3: Monitor peak and minimum hold trigger

Set the peak hold and minimum hold triggers of <F709: Hold function of standard mode> with the
[EASY] key.
The measurement of the minimum and maximum values set for <F709> starts at the instant when
you press the [EASY] key after setting <F750: EASY key function> to "3".
The peak hold and minimum hold values are displayed in absolute values.
• How to operate the operation panel -> Refer to [3. 1. 1].
Reference
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3]
is lit .
Moves to Hand (panel run).
When bumpless function is selected,
remote operation status remains.
EASY
Moves to Auto (remote).
(The operation status does not
remain even if bumpless function is
selected.)
6-181
E6582062
Hand
(Operation panel)
6. [Advanced] How to use parameters
3
4
6
9