How To Adjust The Scale Of The Meter With The Inverter Stopped - Toshiba TOSVERT VF-AS3 Instruction Manual

2 In the basic parameters of [Setting mode], set
<FMSL: Terminal FM function> to "0: Output
frequency".
The default setting of <FMSL> is "0".
3 In the basic parameters of [Setting mode], select
<FM: Terminal FM adjustment> and press the [OK]
key.
The output frequency of the inverter is displayed in
4
the upper part of the screen, and the output level
(%) of the terminal [FM] in the lower part.
5
4 Turning the touch wheel will change the indication
of the meter and the output level (%) of the terminal
[FM] in the lower field of the screen. Adjust the
scale so that the indication of the meter matches
9
the output frequency.
5 Press the [OK] key to complete the adjustment of the meter.

■ How to adjust the scale of the meter with the inverter stopped

You can adjust the scale of the meter even at the inverter stop state.
When <FMSL: Terminal FM adjustment> and <F670: Terminal AM adjustment> are set "22", signal
value is fixed at the following values.
<FMSL>/<F670>
• 0, 1, 5, 6, 7, 10, 13, 62, 63, 79, 130, 131, 132, 133, 134, 135, 150, 151, 152, 153, 154, 159
• 2, 11, 12, 108
• 3, 4
• 8, 9, 64, 65, 155, 156
• 14, 15, 16, 34, 35
• 17
• 18, 19
• 20, 21
5. [Fundamental operation] How to use parameters
: Terminal FM function
FMSL
: Terminal FM adjustment
FM
: Default setting
typ
: Region setting check
FMSL
: Parameter mode select
PSEL
FM
Output frequency
Min: 0.1
X1000
: Maximum frequency (FH)
: 200% of rated current
: 150% of rated voltage
: 250% of rated torque
: Maximum value of OL counter
: %ED value of braking resistor
: 200% of rated power
: 1000 x F749
5-22
E6582062
RUN 60.0Hz
15:12
Basic parameters
0
100.0%
0
1
0
RUN 60.0Hz
15:11
:Terminal FM adjustment
60.0Hz
100.0%
Max: 250.0
X100 X10 X1