Enabling And Disabling Ipv6 Checksum Support; Enabling And Disabling Ipv6 Checksum Calculations For Bfd On A Router - Cisco ASR 9000 Series Configuration Manual

Enabling and Disabling IPv6 Checksum Support

Command or Action
Example:
RP/0/RSP0/CPU0:router(config-bfd)# dampening
initial-wait 30000
Step 4 commit
Enabling and Disabling IPv6 Checksum Support
By default, IPv6 checksum calculations on UDP packets are enabled for BFD on the router.
You can disable IPv6 checksum support for BFD on the entire router, or for a particular interface. These
sections describe about:
The command-line interface (CLI) is slightly different in BFD configuration and BFD interface
Note
configuration. For BFD configuration, the disable keyword is not optional. Therefore, to enable BFD
configuration in that mode, you need to use the no form of the command.

Enabling and Disabling IPv6 Checksum Calculations for BFD on a Router

To enable or disable IPv6 checksum calculations globally on the router complete the following steps:
SUMMARY STEPS
1. configure
2. bfd
3. ipv6 checksum [disable]
4. commit
DETAILED STEPS
Command or Action
Step 1
configure
Step 2
bfd
Example:
RP/0/RSP0/CPU0:router(config)# bfd
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.1.x
216
Purpose
The value for maximum-wait should be greater than the
value for initial-wait.
The dampening values can be defined for bundle member
interfaces and for the non-bundle interfaces.
Purpose
Enters BFD configuration mode.
Implementing BFD
OL-30423-03