Enabling Or Disabling Obfl - Cisco ASR 9000 Serie Configuration Manuals

Onboard Failure Logging

Enabling or Disabling OBFL

OBFL is enabled for all nodes by default and is active until disabled for a specified node or for all nodes.
Do not deactivate OBFL without specific reasons since the OBFL data is used to diagnose and resolve
Caution
problems in FRUs.
There are no configuration requirements other than to enable and disable OBFL.
SUMMARY STEPS
1. admin
2. configure
3. hw-module {all | subslot node-id} logging onboard [disable | severity {alerts | emergencies}]
4. commit
DETAILED STEPS
Command or Action
Step 1 admin
Example:
RP/0/RSP0/CPU0:router# admin
Step 2
configure
Example:
RP/0/RSP0/CPU0:router(admin)# configure
RP/0/RSP0/CPU0:router(admin-config)#
Step 3 hw-module {all | subslot node-id} logging
onboard [disable | severity {alerts | emergencies}]
Example:
RP/0/RSP0/CPU0:router(admin-config)#
hw-module all logging onboard severity
alerts
Step 4
commit
Cisco ASR 9000 Series Aggregation Services Router System Monitoring Configuration Guide, Release 4.2.x
Purpose
Enters administration EXEC mode.
Enters administration configuration mode.
Configures the severity level for the syslog messages that are
logged into the OBFL storage device.
• Use the severity keyword to specify the severity for the
syslog message that is logged into the OBFL storage device.
• Use the alerts keyword to specify that both emergency and
alert syslog messages are logged. The default is the alerts
keyword.
• Use the emergencies keyword to specify only the emergency
syslog messages are logged.
Enabling or Disabling OBFL
315