Ip Address Problems - RADVision L2W-323 User Manual

IP Address Problems

If you experience difficulty setting L2W-323 Gateway IP address parameters (IP address,
default router IP address and IP subnet mask) using the system configuration software,
OnLAN Configure 323, an alternate method is to connect the configuration PC to the
Gateway console (serial) port and run a terminal session. Then run OnLAN Configure 323
to define the other Gateway parameters.
Defining IP Addresses via a Terminal Session
#"
To establish a terminal session between the PC and the Gateway
Note: The Gateway and configuration PC do not have to be disconnected from the LAN.
1. Make sure the Gateway unit is turned off.
2. Connect the 9-pin male connector of the null modem cable to the console (serial) port
on the front panel of the Gateway and connect the cable's nine-pin female connector to
the configuration PC's COM 1 port (alternately, you can connect the cable's 25-pin
male connector to the PC's COM 2 port, but this may require a female/female adapter).
3. Use Windows HyperTerminal™ or a similar application to open a console session. Set
the following parameters for Windows HyperTerminal:
!" Port Settings:
Rate=9600
Data bits=8
Parity=none
Stop bits=1
Flow control=none
!" Properties:
Function, arrow, and Ctrl keys act as=Terminal keys
Emulation=ANSI
Backscroll buffer lines=500
!" Terminal Setup:
Underline=enabled
Blink=enabled
!" ASCII Setup:
Wrap lines that exceed terminal width=enabled
Note: All other values are default values.
IP Address Problems
9-11