Connecting Cables to the Device
About this task
Follow the safety guidelines described in the Safety Guide during this procedure, and follow this
procedure to connect the power and serial cables supplied with the accessories kit.
Procedure
1. On the rear side of the device, connect the power cable to the AC power connector (see
2. Connect the other end of the power cable to the mains.
3. Use a serial cable to connect a PC to the device's serial port. This connection is required for
Configuring the Device IP Addresses
Before you begin
Make sure you have these items:
• Dedicated IP address for the device
• Dedicated subnet mask for the device
• IP address of the default router which the device uses to communicate over the network
Deployment Guide for Scopia TIP Gateway Version 8.2
Figure 15: Rear panel of the device
local configuration and maintenance.
Important:
Do not connect a screen or a keyboard to the device directly. Define the device's basic
settings via the serial connection only.
on page 25).
Figure 15: Rear panel of the device
Setting up the Scopia TIP Gateway | 25