Fcc And Industry Canada Compliance - RADVision L2W-323 User Manual

FCC and Industry Canada Compliance

This section describes the requirements for compliance with Federal Communications
Commission (FCC) Rules and Industry Canada CS-03 standard.
FCC Registration and Requirements
The following paragraphs describe requirements and information based on FCC rules.
Service
If you experience problem with the RADVision L2W-323 Gateway product, contact
RADVision Ltd. customer support at 1-201-529-4300 for information on service or repairs.
The telephone company can ask you to disconnect the equipment from the network until the
problem is corrected or until you are sure that the equipment is not malfunctioning.
FCC Rules, Part 15
The RADVision L2W-323 Gateway product has been tested and comply with the limits for
a class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual,
can cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference in the user's expense.
FCC Rules, Part 68
1. FCC Part 68 Registration
The RADVision L2W-323 Gateway product complies with FCC Rules, Part 68. At the
equipment cover of the system is a label contains, among other information, the FCC
registration number. If requested, this information must be given to the telephone company.
2. REN
The ringer equivalence number (REN) is used to determine the quality of devices which
may be connected to the telephone line. Excessive RENs on the telephone line may result in
the devices not ringing in response to an incoming call. In most, but not all areas, the sum of
E-1