Setting The Ip Address Of The Device - RADVision SCOPIA TIP Deployment Manual

Step 2
Step 3
Note

Setting the IP Address of the Device

Use the serial port on the back panel of the device to connect it directly to a PC to assign an
IP address. You must assign the IP address before you connect the device to the network.
Before you begin
Make sure you have these items:
Procedure
Step 1
Step 2
Step 3
Step 4
RADVISION | Deployment Guide for SCOPIA TIP Gateway Version 8.0
Figure 4-9
Connect the other end of the power cable to the mains.
Use a serial cable to connect a PC to the device's serial port. This connection is required for
local configuration and maintenance.
Do not connect a screen or a keyboard to the device directly. Define the device's
basic settings via the serial connection only.
•
Dedicated IP address for the device
•
Dedicated subnet mask for the device
•
IP address of the default router which the device uses to communicate over the network
•
A PC with an available serial port. It should have terminal emulator software installed like
SecureCRT or PuTTY.
•
Serial cable provided with the device.
Connect the power cable but do not switch on the device.
Connect the serial port to a PC with terminal emulator software.
Start the terminal emulation application on the PC.
Set the communication settings in the terminal emulation application on the PC as follows:
Rear panel of the device
Setting up the SCOPIA TIP Gateway | 20