Single Number Access To A Group Of Terminals - RADVision L2W-323 User Manual

Advanced Gatekeeper Configuration

Single Number Access to a Group of Terminals

To allow single number access to a group of terminals, you have to define these terminals as
service providers.
#"
To define a terminal as a service provider you have to
1. Define the service in the Gatekeeper Services Definition Table.
2. Define the service prefix for the terminals in the group as an additional phone number.
#"
To define the service for the Gatekeeper
1. From the Gatekeeper Services Definition Table screen, click Add. The Services
Definition screen is displayed. See Figure 40 page 6-3.
2. In the Description field, type a description for this service.
3. In the Prefix field, type a prefix. Remember that prefixes can be can be up to 31
characters long and valid characters are 0 through 9 and pound (#), asterisk (*) and
comma (,).
4. Select the Public and Default check boxes.
5. Click OK. This service is added to the Services Definition Table.
#"
To define the service prefix for the terminals in the group as an additional phone
number. This procedure depends on the registration policy of the terminal
!" If the terminal does not support the RAS protocol and has to be predefined, follow the
steps in "Adding a New Endpoint," page 6-12 to predefine the endpoint or in "Editing
an Existing Endpoint," page 6-16 if the terminal is already predefined. Add the service
prefix to the Phone Number text box.
!" If the terminal supports dynamic registration, you can either add the service to its
configuration file or predefine it as you would a terminal that does not support the
RAS protocol.
6-4