Connecting A Pc - RADVision L2W-323 User Manual

Installing the L2W-323 Gateway

Connecting a PC

You can connect the Gateway to a PC to access the Remote Diagnostics utility or for special
configuration. The terminal software used on the PC can be any standard terminal emulator
such as HyperTerminal™.
#"
To connect the Gateway console port to a PC
1. Verify the terminal software used on the PC has the following communications
parameters:
!" Baud rate:
!" Data bits:
!" Stop bits:
!" Parity:
!" Flow control:
2. Connect the 9-pin male connector of the cable to the Gateway console port.
3. Connect the 9-pin female connector to the PC serial port.
4. Run the Hyper Terminal (or other terminal emulator) and press Ctrl+X to restart the
Gateway.
Note: When the Gateway is connected via the console port to a PC running Windows NT,
restarting the PC will also cause the Gateway to restart.
3-10
9600
8
1
none
none