Configuring An Ip Address - RADVision SCOPIA 100 Quick Start Manual

C IP
ONFIGURING AN
A
DDRESS
Procedure
1. At the colon type N.
The Default Network Port Values screen
displays.
Enter IP Address for Interface No. 1
Without leading zeros <
172.27.20.194>:
Enter Default Router IP Address
Without leading zeros <
Enter IP Mask
Without leading zeros <
Updating NVRAM
Updating BOOT LINE PARAMS with new IP
Figure 3
2. Type the IP address, default router IP address and
IP subnet mask as shown in
to proceed from one parameter to the next.
3. Press Enter to finalize the new settings. The
Gateway returns to the network configuration Main
menu displayed at
4. At the colon type Q to quit the network
configuration Main menu and start the Gateway. If
you have changed any of the settings in the
network configuration Main menu (IP address,
default router IP address or IP subnet mask) typing
Q resets the Gateway with the new settings.
Default Network Port Values
Screen
Figure
Figure 2.
Assign an IP Address to the Gateway 11
(Figure 3)
172.27.37.254>:
172.27.37.254>:
3. Press Enter