Table of Contents
Advertisement
Troubleshooting the L2W-323 Gateway
4.
Turn on the Gateway to start a terminal session. The message: "Press any key to start
configuration..." appears (if no message appears, press CTRL+X and wait for the
message). Press any key within six seconds of receiving the message to display a menu
of configuration options.
5.
Enter 1 (the number one) and press Enter; again enter 1 (the number one) and press
Enter.
6.
Enter the IP address for Interface No. 1 and press Enter (the address must be entered
in dotted decimal format without leading zeroes, for example, 170.4.10.20).
7.
Enter the default router IP address and press Enter (the address must be entered in
dotted decimal format without leading zeroes, for example, 170.4.10.20).
8.
Enter the IP subnet mask in hexadecimal notation and press Enter. The PC then
displays configuration information and the Gateway automatically reboots.
9.
When Ready appears on the PC, disconnect the cable that connects it to the Gateway
and close the terminal session.
After you set the IP addresses, run OnLAN Configure 323. Note that the Select Unit screen
will display the IP address of the Gateway that you defined above in the list of RADVision
units. Select it from the list and continue to configure the Gateway. You will notice that the
IP addresses defined above will appear in their appropriate screens during the configuration
procedure.
9-12
Advertisement
Table of Contents
