Programming Remote Controls And Two-Way Keyfobs - Eaton i-on16 Administrator's And User Manual

i-on16
Note: If you do not wish the output to switch on and off
at the same time every day then make sure
each day of the week is set to "Yes".
30. Press  when you have finished
making changes.
The keypad gives a double "beep"
confirmation tone. The keypad
display shows:
31. Press  to leave the menu.
Note: You can switch the output on and off from the Menu by selecting
Outputs On/Off (see page 81).
If you want to program a remote control to control the output, see
page 72.
Programming Remote Controls and Two-way
Keyfobs
Master users can re-program buttons on an i-fb01, or the "*" button on a
FOB-2W-4B, after the devices have been assigned to a user.
Programming Set/Unset
To program an i-fb01 remote or the FOB-2W-4B "*" button to set or unset:
1. Make sure the display shows the
standby screen.
2. Press .
3. Key in your access code (or
present a tag).
Press  until you see:.
4.
Press .
5.
Press  until the display shows:
6.
Press .
7.
















4. Administration
Page 69