Using A Two-Way Key Fob - Eaton i-on16 Administrator's And User Manual

i-on16

Using a Two-Way Key Fob

Note:
1. You must ask your Master User to provide a suitably programmed
Two-Way Key Fob, see page 69.
2. If your system is certified to BS8243 (ask your Installer) then do
not use a FOB-2W-4B as it will not comply with the entry and exit
requirements. (It could however be used on a compliant system to
unset the system if the building is locked using electronic locks on
the entry doors.)
Setting the System
Press and
hold:
Part Setting the System
Press and
hold:
Unsetting the System
Press and
hold:
The setting LED flashes red three times.
The system sets. The control unit sends a
message to the fob.
The setting LED glows green for three
seconds.
The part setting LED flashes red three
times.
The system part sets. The control unit
sends a message to the fob.
The part setting LED glows green for three
seconds.
The un-setting LED flashes red three times.
The system unsets.
The unset LED glows green for three
seconds.
3. Setting and Unsetting
Page 29