Using A Remote Control - Eaton i-on16 Administrator's And User Manual

i-on16
Unsetting
1. Enter by the designated entry door.
2. Key in a valid access code (or present your proximity tag).
3. Press .
Silencing an Alarm
1. Key in a valid access code (or present your proximity tag).
2. Press .
Using a Proximity Tag With a Radio Keypad
If you wish to use a Proximity Tag with the radio keypad in place of an
access code, then hold the tag up against the proximity tag sensor (see
Figure 7).
The keypad glows blue and gives a "click" to show that it has recognised
the tag.
Note: The radio keypad does not show the status of the alarm system at all.
The left hand "Transmit" LED glows only to show that the keypad is
sending a command to the control unit.

Using a Remote Control

Setting
Note: You must ask your Master User to provide a suitably programmed
remote control, see page 69.
Secure all your windows and doors.
Proximity tag sensor
Figure 7. Radio Keypad
3. Setting and Unsetting
"
Transmit" LED
Page 27