Drawer Feed Copying - Toshiba e-STUDIO163 Service Manual

4.2.3

Drawer feed copying

1) Press the [START] button
→LED "START" ON → OFF
→ CIS LED ON
→ Scan motor ON → CIS unit move forward
→ Polygonal motor rotates in high speed
→ Main motor and exit motor ON
- The drum, fuser unit, developer unit and exit roller are driven.
2) Drawer paper feeding
→ Main charger, developer bias and discharge LED ON. Fans are rotated in high speed. Pickup
solenoid ON.
- Feed roller start to rotate.
→ Paper reaches the registration roller.
- The registration sensor is turned ON and aligning is performed.
→ Registration clutch OFF after a certain period of time
3) After the scanning operation:
→ Registration clutch ON after a certain period of time
→ Copy counter operates
4) After the registration clutch is turned ON:
→ Transfer charger ON after a certain period of time
→ Copy counter operates
5) Completion of scanning
→ Scan motor OFF
→ CIS LED OFF
→ Registration clutch OFF (after the trailing edge of the paper passed the registration roller)
→ Ready state
6) Paper exit
→ Exit sensor detects the trailing edge of the paper
→ Main charger, developer bias and discharge LED OFF
→ Polygonal motor, main motor and exit motor OFF
→ Drum, fuser unit and developer unit stop
→ Fans return to the ready rotation
→ LED "START" ON and the equipment enters the ready state
December 2005 © TOSHIBA TEC
paper is transported to the transfer area.
e-STUDIO163/203 GENERAL OPERATION
4 - 3
4