General Descriptions For Pm Procedure - Toshiba e-STUDIO2330C Service Handbook

Multifunctional digital color systems

Hide thumbs Also See for e-STUDIO2330C:

Table of Contents

General Descriptions for PM Procedure

Ask the user about the current conditions of the equipment and note them down.

Before starting maintenance, make some sample copies and store them.

See the replacement record and check the parts to be replaced in the PM support mode (6S-

2) or list printing mode (9S-103).

: [6] + [START] + [POWER] ON

9S-103 : [9] + [START] + [POWER] ON

PM SUPPORT CODE LIST

MM-DD-YY HH:MM

DRUM BLADE(K)

DRUM BRUSH(K)

MAIN CHARGER NEEDLE(K)

CHARGER CLEANING PAD(K)

Turn OFF the power and make sure to unplug the equipment.

Perform a preventive maintenance using the following checklist and illustrations. Refer to the

Service Manual if necessary.

Plug in the equipment after the maintenance has been finished. Then turn ON the power and

make some copies to confirm that the equipment is working properly.

e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C

PREVENTIVE MAINTENANCE (PM)

OUTPUT PAGES/

PM OUTPUT PAGE/

DEVELOP COUNTS DEVELOP COUNTS

DRIVE COUNTS

PM DRIVE COUNTS

Show Quick Links

Table of Contents