Developing Cylinder; Removing The Developing Cylinder - Canon iR7086 Series Service Manual

[1]

7.10.10 Developing Cylinder

7.10.10.1 Removing the Developing Cylinder

iR7105 / iR7095 / iR7086
1) Remove the developing assembly.
2) Remove the hopper assembly.
3) Remove the blade unit.
4) Remove the three mounting screws [1] from the rear, and detach the de-
celeration gear retainer [2].
[1]
5) Remove the three gears [1].
[1]
6) Remove the E-ring [1], and detach the pressure arm [2].
[1]
F-7-88
[2]
[1]
F-7-89
F-7-90
7) Remove the E-ring [1], gear [2], pressure roll [3], washer [4], grip ring [5],
seal [6], butting roll [7], washer [4], and bearing [8] in the order indicated.
0010-8847
[1]
8) Remove the E-ring [1] and the pressure arm [2] at the front.
9) Remove the C-ring [1], washer [2], pressure roll [3], seal [4], washer [2],
butting roll [5], C-ring [1], and bearing [6]; the, remove the two screws
[7], and detach the bushing [8] and then the developing sleeve [9].
[9]
[8]
Do not leave fingerprints or oil on the surface of the developing cylinder.
Wipe off any with lint-free paper. (Do not use solvent.)
[2]
F-7-91
[4]
[7]
[6]
[5]
[4]
[3]
[2]
F-7-92
[1]
F-7-93
[7]
[6]
[1]
[5]
[2]
[4]
[3]
[2]
[1]
F-7-94
Chapter 7
[1]
[8]
[2]
7-39