Chapter 17
17.4.2 FEEDER
17.4.2.1 FEEDER Items
iR7105 / iR7095 / iR7086
<ADJUST>
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item
DOCST
Use it to adjust the original stop position for ADF mode (pickup from the original tray).
range: -7 to 7 (unit: 0.5 mm)
A higher value decreases the lead edge margin.
<Procedure>
1) Place the original in the original tray.
2) Select the item, and enter the appropriate value; then, press the OK key.
3) Press the OK key so that the original will be picked up.
4) Open the ADF, and check the original stop position.
5) Press the OK key so that the original is delivered.
DOCST-M *
Use it to adjust the original stop position for ADF mode (pickup from the manual feeder tray).
range: -7 to 7 (unit: 0.5 mm)
Use the same procedure used for FEEDER > ADJUST > DOCST.
LA-SPEED
Use it to adjust the original transport speed for ADF stream reading mode.
A higher setting will increase the speed.
range: -30 to 30 (unit: 0.1%)
STRD-S *
Use it to adjust the scanner stop position for stream reading mode (small-size).
range: -7 to 7 (unit: 0.5 mm)
bigger the value, bigger the lead edge while smaller the value, smaller the lead edge
STRD-L *
Use it to adjust the scanner stop position for stream reading mode (large-size).
range: -7 to 7 (unit: 0.5 mm)
bigger the value, bigger the lead edge while smaller the value, smaller the lead edge
RVM-SPD *
Use it to adjust the speed of the reversal motor.
A higher setting will increase the speed.
range: -30 to 30 (unit: 0.1%)
17-44
T-17-30
FEEDER > ADJUST
Description
0011-6094
Level
1
1
1
1
1
2