Unpacking - Canon iR7086 Series Service Manual

17) Open the upper right cover, and mount the face cover (small, large).
18) Close the upper right cover.
If condensation is found on the outside or inside of the machine at this point,
stop the work and wait unit the machine becomes fully used to the room
temperature. Resume the work after making sure that the machine is free of
condensation.

2.2.3 Unpacking

iR7095P
1) Unpack the machine.
2) Remove the grip cover (rear) [1] found on the right side of the machine
using a flat-blade screwdriver, and shift up the grip [2] found at the rear.
3) Take out the grip [1] from the contents box.
[1]
4) Open the upper right cover and slide the face cover (small) [1] in the di-
rection of A arrow. Then, detach the face cover (large) [2] in the direction
of B arrow.
[1]
[2]
F-2-22
[2]
[1]
F-2-23
F-2-24
5) Insert the grip [1] taken out in step 3) into the machine at an angle while
holding down the spring [2]; then, keep the grip in horizontal orientation
so that the claw [3] is hooked on the plate at the rear.
0012-2132
[1]
6) Close the upper right cover.
7) Shift up the grip (front, rear) [1] found on the left side of the machine.
[1]
Be sure to go through steps 8) and 9) in correct sequence; otherwise, the
machine can become displaced.
8) Holding the grips (front, rear) on the delivery side of the machine, lift the
machine slightly to remove the pad.
At this time, put away the plastic bag toward the pad.
[A]
[B]
[2]
[1]
F-2-25
[3]
[2]
F-2-26
F-2-27
Chapter 2
[1]
2-13