Parts Replacement Procedure - Canon iR7086 Series Service Manual

Chapter 8

8.11 Parts Replacement Procedure

8.11.1 Cassette Pickup Assembly
8.11.1.1 Removing the Right Deck / Cassette Pickup
Assembly
iR7105 / iR7095 / iR7086
The removal procedure of a right door and a left door is the same. An illus-
tration makes a right door an example and explains it.
1) Slide out the right deck / cassette 3 / cassette 4.
2) Open the right upper cover and the right lower cover.
An attempt to remove the pickup assembly without removing the deck will
cause the lifter to get trapped, not holding the pickup assembly from sliding
out.
3) Remove the mounting screw [1], and detach the connector cover [2]; then,
disconnect the connector [3].
4) Remove the three mounting screws [4], and detach the pickup assembly
[5].
[4]
[5]
8.11.1.2 Removing the Vertical Path 3/4 Sensor and the
Cassette 3/4 Pickup Sensor
iR7105 / iR7095 / iR7086
1) Remove the cassette 3/4 pickup assembly.
2) Remove the screw, and detach the static eliminator [2].
3) Remove the screw [3], and detach the pickup assembly sensor base.
[1]
4) Disconnect the connector [1] (1 pc. each), and free the claw; then, detach
the vertical path 3/4 sensor [2] and the cassette 3/4 pickup sensor [3].
8-36
[4]
[2]
[3]
[1]
F-8-56
[2]
[4]
[3]
F-8-57
0011-0030
8.11.2 Cassette Lifter Motor
8.11.2.1 Removing the Lifter Motor (M16/M17) of the
Cassette (3/4)
iR7105 / iR7095 / iR7086
1) Slide out the front deck (right); then, slide out the cassette 3/4.
2) Remove the front lower right cover of the cassette assembly as instructed
under "Removing the Vertical Path Roller 2."
3) Remove the two fixing screws [1] of the lifter motor (M16/M17), and dis-
connect the connector [2]; then, detach the lifter motor [3].
8.11.3 Right Deck Pickup Assembly
8.11.3.1 Removing the Right Deck / Cassette Pickup
Assembly
iR7105 / iR7095 / iR7086
The removal procedure of a right door and a left door is the same. An illus-
tration makes a right door an example and explains it.
0011-0032
1) Slide out the right deck / cassette 3 / cassette 4.
2) Open the right upper cover and the right lower cover.
An attempt to remove the pickup assembly without removing the deck will
cause the lifter to get trapped, not holding the pickup assembly from sliding
out.
3) Remove the mounting screw [1], and detach the connector cover [2]; then,
disconnect the connector [3].
4) Remove the three mounting screws [4], and detach the pickup assembly
[5].
[3]
[1]
[1]
[2]
F-8-58
[2]
[3]
[1]
[2]
F-8-59
0010-8958
[3]
0011-8492