Canon iR7086 Series Service Manual page 83

[4]
Be sure to adjust the length of the cable [1] so that it is inside the plate [2].
[1]
[3]
MEMO:
If the control panel is tilting, go through the following steps to correct:
1) Loosen the 4 screws [1] found on the back of the control panel.
2) Shift the control panel [2] to its correct orientation, and tighten the screws
loosened previously.
[2]
21) Peel off the protective sheet of the arm cover 4.
22) Mount the arm cover 4 [1] from behind the arm unit.
- screw (binding; M4X10) [2]
[2]
[3]
[2] [1]
F-2-90
[4]
[2]
[3]
[1]
[1]
F-2-91
23) Mount the lock hinge cover R [1].
- 2 bosses [2]
- 2 screws (P tightening; M3X10) [3]
[2]
[1]
[2]
24) Mount the lock hinge cover L [1].
- 2 bosses [2]
- screw (TP; M3x6) [3]
MEMO:
Keep the arm and the control panel upright to facilitate mounting of the lock
hinge cover R.
[2]
[1]
25) Tilt the control panel [1] in the direction of the arrow.
26) Fit the Hinge slide cover [1] in the direction of the arrow.
27) Fix the Hinge slide cover in place.
Chapter 2
F-2-92
T-2-1
[3]
F-2-93
[1]
F-2-94
[1]
F-2-95
[3]
[1]
2-25