Chapter 10
[5]
[2]
10.5.1.5 Upper Vertical Path Cover
10.5.1.5.1 Removing the Upper Vertical Path Cover
iR7105 / iR7095 / iR7086 / iR7095P
1) Open the Manual feed tray unit.
2) Open the upper vertical path cover [2].
3) Holding the Manual feed tray unit [1] slightly up, pull out the upper
vertical path cover [2] upward.
10.5.1.6 Upper Front Cover Unit
10.5.1.6.1 Removing the Upper Front Cover Unit
iR7105 / iR7095 / iR7086 / iR7095P
1) Remove the inside upper cover.
2) Remove the flat-headed screw [1] (1 pc. each), and detach the 2 magnet
catches [2].
3) Remove the face plate [3], and remove the 3 screws [4]; then, detach
the upper front cover unit [5].
[3]
[2]
[4]
[4]
[4]
If the card reader is mounted, be sure to disconnect the connector [1].
10-12
[3]
[4]
[5]
[1]
[6]
F-10-13
0017-9840
[1]
[2]
F-10-14
0017-9841
[1]
[2]
[5]
[4]
F-10-15
10.5.1.7 Upper Rear Cover
10.5.1.7.1 Removing the Upper Rear Cover
iR7105 / iR7095 / iR7086 / iR7095P
1) Remove the ADF.
2) Remove the 3 screws [1], and detach the right pocket plate [2].
3) Remove the 3 screws [3], and detach the left pocket plate [4].
[3]
[4]
[3]
Mark the position of the screw [3] so that the left pocket plate [4] may be
mounted back to its
original position.
4) Remove the upper rear cover [5].
10.5.1.8 Main Controller Box Cover
10.5.1.8.1 Removing the Main Controller Box Cover
iR7105 / iR7095 / iR7086 / iR7095P
1) Remove the 4 screws [1], and detach the main controller box cover [2].
10.5.1.9 System Connector Cover
10.5.1.9.1 Removing the System Connector Cover
iR7105 / iR7095 / iR7086 / iR7095P
1) Remove the 2 screws [1], and detach the system connector cover [2].
[1]
F-10-16
0017-9842
[5]
[2]
[1]
[1]
F-10-17
0017-9843
[1]
[2]
[1]
F-10-18
0017-9844