Mounting The Main Thermistor; Sub Thermistor; Removing The Sub Thermistor; Thermal Switch - Canon iR7086 Series Service Manual

[1]
When shifting the thermistor assembly to the rear, take care not to damage
the fixing roller with the thermistor.
5) Remove the 2 thermistor retaining springs [1], and detach the main ther-
mistor [2].
[1]

9.5.6.2 Mounting the Main Thermistor

iR7105 / iR7095 / iR7086
When mounting the main thermistor to the fixing assembly, be sure that the
tie-wrap [1] is as shown.
The tie-wrap serves as a stopper by butting against the claw [2].
Check also to be sure that the main thermistor and the fixing roller are not
away from each other.
[2] [1]

9.5.7 Sub Thermistor

9.5.7.1 Removing the Sub Thermistor

iR7105 / iR7095 / iR7086
1) Slide out the fixing assembly.
2) Remove the fixing web and the oil pan.
3) Remove the fixing harness cover.
4) Disconnect the connector [1] and remove the screw [2]; then, detach
the sub thermistor assembly [3].
[2]
[3]
F-9-37
[2]
[1]
F-9-38
F-9-39
[1]
5) Remove the screw [1], and detach the sub thermistor [2].

9.5.8 Thermal Switch

0010-9400

9.5.8.1 Removing the Thermal Switch Unit

iR7105 / iR7095 / iR7086
1) Remove the fixing assembly.
2) Remove the fixing web; then, remove the 2 screws [1] and the oil pan
[2], and detach the fixing harness cover [3].
[1]
3) Remove the faston [1], and remove the 2 screws [2]; then, detach the elec-
trode assembly [3] and the thermal switch holder [4].
0010-9448
4) Remove the 4 screws [1], and detach the thermal switch unit [2].
[2]
F-9-40
[1]
F-9-41
[2] [3]
F-9-42
[3] [2] [1] [4]
F-9-43
Chapter 9
[3]
[2]
0010-9450
[1]
[2]
9-15