Manual Feed Pickup Solenoid; Position Of The Pickup Roller Release Solenoid Of The Manual Feed Tray - Canon iR7086 Series Service Manual

Chapter 8
[2]
[3]
6) Open the manual feed tray.
7) Remove the 11 mounting screws [1], and detach the manual feed tray
pickup assembly [2].
[1]
[1]
[1]
8) Remove the 2 mounting screws [1], and detach the upper guide plate [2].
[2]
9) Remove the 2 mounting screws [1] found at the bottom, and detach the
lower cover [2].
[1]
10) Remove the 2 mounting screws [1], and detach the middle guide plate
[2].
8-42
[1]
F-8-93
[1]
[2]
[1] [1]
F-8-94
[1]
F-8-95
[2]
[1]
F-8-96
[2]
11) Remove the 2 mounting screws [2] of the sensor unit [1].
[2]
12) Disconnect the connector [1], and detach the sensor unit [2].
13) Remove the sensor [3] from the sensor unit [2].
[3]
[2]

8.11.13 Manual Feed Pickup Solenoid

8.11.13.1 Position of the Pickup Roller Release Solenoid
of the Manual Feed Tray
iR7105 / iR7095 / iR7086
To make fine adjustments, slide the solenoid in the direction of A so that the
gap between the shutter [1] and the shutter plate [2] is 0.4 +/-0.2 mm while
the solenoid is being pulled.
A
[1]
F-8-97
[2]
[1]
F-8-98
[1]
F-8-99
F-8-100
0010-9043