The width guide rail inside the cassette is equipped with paper size positioning holes, which are marked A through M as shown in Table.
Refer to these markings if the user reports skew movement of paper, thereby deciding whether the paper width is set correctly. (Note that this information is not
disclosed to the user.)
Marking
A
B
C
D
E
F
G
H
I
J
K
L
M
8.4.6 Paper Size
iR7105 / iR7095 / iR7086
The microprocessor on the DC controller PCB determines the size of paper based on the inputs on paper width and paper length.
Table shows the paper size groupings selected in service mode.