Canon iR7086 Series Service Manual page 148

Chapter 2
15) Mount the ferrite core [1] on the cable.
The length [2] should be less than 50mm.
16) Plug the cable [1] into the terminal [2] of voice board.
17) Plug the power cable of host machine into a wall outlet
18) Turn on the main power switch.
19) Check if the voice board is recognized.
Enter service mode (" "->"2"& "8"at the same time ->"
COPIER > DISPLAY > ACC-STS > PCI1
If 'voice board' is indicated for PCI1, the board is correctly recognized by the machine.
3. Making Settings After Installation
To make use of the Voice Guidance Kit-A2 after turning on the host machine, you need to make the following settings in Additional Function:
1) Additional Function > System Setting > Voice Guide Manegement Setting > Use Voice Guide.
2) Select [ON].
3) Press [OK].
default : OFF
2-90
[3] [5]
[1] [5] [2]
F-2-288
[1]
F-2-289
[2]
F-2-290
")
[4] [5]
[3]
[2]
[1]