Removing The Deck (Left) Draw- Out Clutch/Lower Feeder Middle Clutch - Canon iR7086 Series Service Manual

Chapter 8
3) Disconnect the connector [3], and remove the screw [4]; then, detach the
horizontal registration motor [5].
[4]
8.11.22.9 Removing the Deck (left) Draw- Out Clutch/
Lower Feeder Middle Clutch
iR7105 / iR7095 / iR7086
1) Remove the duplexing unit from the main body.
2) Remove the front cover.
3) Remove the two set screws [2] to detach the locking ring [1]; then, dis-
connect the connector [3], and detach the clutch [4]. (Be sure to perform
this for each pair.)
[3]
[2]
[1]
8-48
[1]
[2]
F-8-133
[5]
[3]
F-8-134
[4]
[2]
No gap.
F-8-135
When fixing the lock ring in place, be sure that it is perpendicular in relation
to the D-cut face and one of the 2 set screws.
8.11.22.10 Removing the Lower Feeding Right Clutch
iR7105 / iR7095 / iR7086
1) Remove the duplexing unit from the main body.
2) Remove the front cover.
3) Disconnect the connector [1], and remove the two screws [2]; then, de-
tach the latch plate [3].
[2]
4) Remove the bearing [4] and spacer [5]; then, detach the lower feeding
right clutch [6].
8.11.22.11 Removing the Pre-Confluence Sensor
0010-9366
iR7105 / iR7095 / iR7086
1) Disconnect the connector [1] from the bottom of the duplexing unit; then,
remove the screw [2], and detach the preconfluence sensor [3].
8.11.22.12 Removing the Post-Confluence Sensor
iR7105 / iR7095 / iR7086
1) Remove the two screws [1] from the bottom of the duplexing unit; then,
detach the left deck feeding roller assembly [2].
[1]
[3]
F-8-136
[5]
[4]
[6]
F-8-137
F-8-138
0010-9373
[2]
0010-9374
[1]
[3]
[2]
0010-9375