Exiting Service Modes; Backing Up Service Mode - Canon iR7086 Series Service Manual

Chapter 17
2) Press 2 and 8 simultaneously on the numeric keypad.
3) Press the asterisk key ( )on the operation panel.
The initial screen (see below) now appears.
Copier service modes
ADF service modes
Sorter/finisher service modes
Option board service modes

17.1.3 Exiting service modes

iR7105 / iR7095 / iR7086
When the reset key is pressed once, the display returns to the service mode initial screen.
When the reset key is pressed twice, the service modes are exited, and the display returns to the user screen (standard screen).
When using the ADJUST, FUNCTION or OPTION service mode, be sure to turn the main power switch ON/OFF after exiting the mode.

17.1.4 Backing Up Service Mode

iR7105 / iR7095 / iR7086
At time of shipment from the factory, each machine is adjusted, and the adjustment values are recorded on the Service sheet [1] (attached to the cover of the Service
Book case behind the front cover).
If you have replaced the reader controller PCB, DC controller PCB (or if you have cleared the RAM of these), the ADJUST and OPTION settings will be replaced
by default settings.
If you have made adjustments in the field and changed service mode settings, be sure to print out the Service sheet and store it away (COPIER>FUNCTION>MISC-
P>LBL-PRNT). If the label lacks items, use its margin.
You can also print out a complete list of service mode settings: COPIER>ADJUST/OPTION/COUNTER; COPIER>FUNCTION>MISC-P>P-PRINT.
17-2
Displayed only when the ADF is attached.
Displayed only when the finisher is attached.
(There are no modes for the sorter,
so isn't displayed even
SORTER
when the sorter is attached.)
Displayed only when an option board is
attached.
COPIER
FEEDER
SORTER
BOARD
F-17-3
[1]
F-17-4
0011-5847
0011-5848