[3]
[3]
3) Remove the 2 screws [1], and disconnect the 2 connectors [2]; then, detach
the delivery speed switchover clutch [3].
[1]
[1]
[3]
When detaching the delivery speed switching clutch, take care not to lose the
bearing and washer (rear only) on both sides of the clutch shaft.
4) Disconnect the 2 connectors [1], and remove the 2 screws [2]; then, detach
the curl-removing fan [3].
[2]
[1]
10.5.37 Drum Fan
10.5.37.1 Removing the Drum Fan (FM8)
iR7105 / iR7095 / iR7086
1) Remove the HV-DC PCB.
2) Remove the 2 screws [1], and disconnect that connector [2]; then, de-
tach the drum fan unit [3].
[1]
[4]
[2]
F-10-118
[2]
F-10-119
[3]
[2]
F-10-120
3) Disconnect the connector [1], and remove the 3 screws [2]; then, detach
the drum fan [3].
10.5.38 Pre-Transfer Charging Assembly Fan
10.5.38.1 Removing the Pre-Transfer Charging Assembly
Fan (FM10)
iR7105 / iR7095 / iR7086
1) Remove the process unit cover. (4 screws)
2) Remove the 2 screws [1], and disconnect the 2 connectors [2]; then, de-
tach the fan motor [3].
3) Disconnect the connector [1], and remove the 2 screws [2]; then, detach
the pre-transfer charging assembly fan [3].
0010-9585
[3]
[1]
[2]
[1]
F-10-121
[2]
[1]
[3]
F-10-122
[1]
[2]
[3]
F-10-123
Chapter 10
[2]
0010-9583
10-29