Canon iR7086 Series Service Manual page 644

Chapter 17
*: model equipped with DADF-Q1 (outside Japan: iR7105/7095; inside Japan: All model).
**: model equipped with DADF-M1 (outside Japan: iR7086).
Sub item Description
SL-CHK ** Use it to check the ADF solenoid on its own.
<Procedure>
1) Select the item.
2) Type in the number of a specific part using the keypad.
3) Press the OK key.
4) Press SL-ON to check the operation.
No. and Part
0: locking solenoid
1: stamp solenoid
SL-ON ** Use it to start the operation of the solenoid.
<Procedure>
1) Select the item, and press the OK key to start the motor operation.
2) Press the OK key to stop the operation. (The operation will stop automatically in about 5 sec, but the indication will not change to
'STOP' until the OK key is pressed once again.)
MTR-ON ** Use it to start motor operation.
<Procedure>
1) Select the item, and press the OK key so that the motor will start.
2) Press the OK key to stop the operation. (The operation will stop automatically in about 5 sec, but the indication will not change to
'STOP' until the OK key is pressed once again.)
ROLL-CLN Use it to clean the ADF roller.
**
<Procedure>
1) Select the item so that the roller starts to rotate.
2) While the roller is rotating, clean it by pressing lint-free paper (moistened with alcohol) against it.
3) Select ROLL-CLN to highlight, and press the OK key so that the roller will stop.
FEED-ON ** Use it to check the passage of paper on the ADF on its own.
<Procedure>
1) Select the item, and press the OK key so that paper movement starts according to the operation mode selected using FEED-CHK.
17-56
FEEDER > FUNCTION
Level
1
1
1
1
1