Checking The Connection To The Network; Overview; Checking The Network Connections; Using The Ping Command - Canon iR7086 Series Service Manual

2.3 Checking the Connection to the Network

2.3.1 Overview

iR7105 / iR7095 / iR7086 / iR7095P
The information in this section applies when connecting the host machine to a network.
If the user's network is in TCP/IP environment, use the PING command to see that the network settings are correct.
There is no need to check the settings using the PING command if the use's network is in an IPX/SPX or Apple Talk environment.

2.3.2 Checking the Network Connections

iR7105 / iR7095 / iR7086
1) Go through the shut-down sequence to turn off the main power.
2) Connect the network cable to the machine, and turn on the main power switch.
3) Tell the user's system administrator that the machine has been installed, and ask him/her to make the machine's network settings.
4) When the network settings have been made, go through steps 1) thorough 3) to turn off and then on the main power so that the settings will become valid.

2.3.3 Checking the Network Connections

iR7095P
1) Go through the shut-down sequence to turn off the main power.
2) Connect the network cable to the machine, and turn on the main power switch.
3) Tell the user's system administrator that the machine has been installed, and ask him/her to make the machine's network settings.
4) When the network settings have been made, go through steps 1) thorough 3) to turn off and then on the main power so that the settings will become valid.

2.3.4 Using the PING Command

iR7105 / iR7095 / iR7086
1) Make the following settings in service mode: COPIER > TEXT > NETWORK > PING.
2) Type in the IP address using the control panel keypad, and press the OK key.
3) Press the OK key.
- When the check with the PING command is successful, 'OK' will be indicated; otherwise, 'NG' will be indicated.
Perform the following work only if the machine is connected to a network.
The following additional functions items must be set to 'ON' when making
network settings:
system administrator setup > network setup > change network settings/
check connection.
The following additional functions items must be set to 'ON' when making
network settings:
system administrator setup > network setup > change network settings/
check connection.
The information in this section applies when connecting the host machine
to a network. If the user's network is in TCP/IP environment, use the PING
command to see that the network settings are correct. There is no need to
check the settings using the PING command if the use's network is in an
IPX/SPX or Apple Talk environment.
Chapter 2
0017-8463
0010-9001
0012-2894
0010-9002
2-39