Canon iR7086 Series Service Manual page 103

14) Remove the 2 screws [1] from the top of the card reader base.
15) Mount the card reader [3] using the 2 screws [2] used to hold the face plate in place and the 2 screws [1] you have removed previously.
16) Route the harness [4] and the grounding wire [5] under the card reader as shown and through the edge saddle [6].
17) Remove the toothed screw [1] from the rear of the card reader base.
Fix the grounding wire [2] in place using the toothed screw [1] you have removed.
18) Remove the 2 screws [1] from the front of the card reader base.
Change the orientation of the face plate [2] you have removed in step 13), and fix it in place using 2 screws [1] you have removed previously.
[3]
F-2-174
[1]
[4]
[5]
[6]
F-2-175
[1]
[2]
F-2-176
[2]
[1]
[3]
[2]
[2]
Chapter 2
2-45