Canon iR7086 Series Service Manual page 494

Chapter 13
- Make a thorough check to see that there is no melting, thermal deformation, cracking, or discoloration (yellowish) caused by leakage in the block (front, rear). If
any abnormal condition is noted, replace it with a new one as soon as possible.
- Be sure to check and clean all the way, including the inner side of the block (front, rear).
- Never use a cloth with any metal particles.
- Do not use a moist cloth for areas other than those for which doing so is specifically mentioned. If alcohol has been used, be sure it has dried completely before
putting the part back into the machine.
- Whenever possible, perform scheduled servicing and replacement at the indicated intervals.
[10]
[11]
[12]
Item
[1] pre-exposure lamp
[2] copyboard glass
[3] scanning lamp
[4] standard white plate
[5] reflecting plate
[6] No. 1 through No. 3 mirrors
[7] separation claw
[8] upper roller
lower roller
[9] paper guide
[10] transport assembly
[11] re-pickup assembly
reversing roller
13-12
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
Tool/solvent
alcohol
alcohol
lint-free paper
lint-free paper
blower brush
blower brush or lint-free paper
solvent (#160) and lint-free paper
Cleaning oil
lint-free paper
solvent (#160) and lint-free paper
moist cloth*1
alcohol and lint-free paper
F-13-14
T-13-6
Remarks
cleaning
cleaning
dry wiping
dry wiping
cleaning
cleaning or blowing; if dirt persists, dry wiping with lint-
free paper
cleaning
cleaning
cleaning
cleaning
cleaning
[13]
[14]
[15]
[16]
[17]
[18]
[19]
[20]
[21]
[22]