Mounting The Pickup Assembly; Mounting The Control Panel - Canon iR7086 Series Service Manual

- screw (RS tightening; M4X10) [2]
[2]

2.2.9 Mounting the Pickup Assembly

iR7105 / iR7095 / iR7086 / iR7095P
1) Shift the lever [1] in the direction of the arrow, and remove the pickup roll-
er release spacer [2].
[1]
2) Open the manual feed cover.
3) Push the release button of the front deck (right) and the cassette 3/4, and
slide them out halfway.
4) Slide out the cassette 3/4, and remove the packing tape from where the
host machine and the cassette come into contact (left side of the host ma-
chine and right side of cassette 4).
5) Open the upper right cover [1] and the lower right cover [2], and remove
the 3 pickup roller release spacers [3].
MEMO:
If the deck/cassette is inside the machine, the spacer is locked in place and
cannot be removed; be sure to slide the unit out halfway to unlock it.
[1]
F-2-68
[2]
F-2-69
6) Close the upper right cover and the lower right cover.
7) Close the front deck (right) and the cassette 3/4.
8) Press the release button of the front deck (left), and slide out the deck.
9) Mount the included deck locking plate [1] to the front deck (left).
- screw (RS tightening; M4X10; white) [2]
0010-8957
10) Close the front deck (left).

2.2.10 Mounting the Control Panel

iR7105 / iR7095 / iR7086
1) Remove the upper rear right cover [1].
- 3 screws [2]
[2]
2) Match the 2 bosses [3] of the arm cover 3 [2] with the Control panel arm
unit [1], and fix it in place with a screw (binding; M4X10) [4].
[1]
[2]
[3]
F-2-70
[1]
[2]
F-2-71
[1]
F-2-72
Chapter 2
0011-4903
[2]
2-21