Removing The Double-Feed Sensor (Transmitting) - Canon iR7086 Series Service Manual

[1]
[1]
9) Remove the bushing [1] in the direction of the arrow, and remove the reg-
istration transfer unit [2].
- E-ring [3]
- bushing [4]
[4]
[3]
8.11.24.2 Removing the Double-Feed Sensor
(transmitting)
iR7105 / iR7095 / iR7086
1) Turn over the registration transfer unit, and detach the harness protective
sheet [1].
[1]
2) Disconnect the cable [1].
- 1 edge saddle [2]
- 1 clamp [3]
- 1 connector [4]
[1]
F-8-153
[2]
[1]
F-8-154
F-8-155
3) Remove the double-feed sensor assembly [1].
- 1 screws [2]
4) Remove the double-feed sensor (transmitting) [1].
- 1 screw [2]
- 1 sensor holder [3]
0011-8283
8.11.25 Double Feeding Detection Sensor ( Reception )
8.11.25.1 Before Starting the Work
iR7105 / iR7095 / iR7086
1) Remove the developing assembly.
2) Remove the primary charging assembly.
3) Remove the pre-transfer charging assembly.
4) Remove the process unit.
8.11.25.2 Removing the Double-Feed Sensor (receiving)
iR7105 / iR7095 / iR7086
1) Remove the pre-transfer charging assembly fan duct assembly [1].
- 4 screws [2]
[4] [1] [3] [2]
F-8-156
[2] [1]
F-8-157
[2]
[3]
[1]
F-8-158
Chapter 8
0011-8282
0011-8284
8-51