Canon iR7086 Series Service Manual page 80

Chapter 2
[3]
[2]
3) Route the control panel interface cable through the Control panel arm unit
[1], and fix it in place with the edge saddle [3].
[2]
4) Hook the claw [2] of the Control panel arm unit [1], and tighten the 4
screws (binding; M4X10) [3] and 4 screws [4].
- Be sure to tighten the screws in the correct order.
- Do not drop the screws.
[1]
[3]
5) Adjust the control panel interface cable [1] so that the length [4] from the
edge saddle [2] and the seal [3] is about 5 cm, and fix it in place using the
edge saddle.
2-22
[4]
[3]
[1]
F-2-73
[1]
[3]
F-2-74
[4]
[2]
[3]
F-2-75
[4]
[1]
[3]
6) Hook the claw [2] of the cover support plate [1], and fix it in place using
2 screws (binding; M4X10) [3].
[3] [2]
7) Open the DF, and lead the control panel interface cable [2] along the arm
cover 2 [1]; then, put the cover over the control panel arm unit.
[2]
When putting the arm cover 2 in place, be sure it is correctly oriented in
relation to the plate [1].
[1]
8) Tighten the screw (binding; M4X10) [1].
[2]
F-2-76
[3] [1]
F-2-77
[1]
F-2-78
[1]