I. INSTALLATION
1. Choosing Location
The following requirements should be
met when installing this machine. The service
technician should inspect the planned loca-
tion before delivery.
You can refer the user manual or setup
guide for details.
Ensure to provide a carry-in route and a
means of transporting this machine in the
packing condition. The packing weight is
approx. 30 kg, and the dimensions are ap-
prox. 600(W) 680(D) 450 (H) mm.
There should be an enough space around
this machine for operation, maintenance
and ventilation.
Figure 4-101
This machine should not be exposed to
open flames, dust, ammonia fumes, direct
sunlight, vibration, or electromagnetic
wave.
If it has to be placed in a sunny place, the
windows should be curtained to avoid di-
rect sunlight.
COPYRIGHT © CANON ELECTRONICS INC. 2018
This machine should not be installed near
water faucets, boilers, humidifiers, refrig-
erators, etc. and should not be put in a lo-
cation where the temperature or humidity
changes abruptly.
Do not install this machine on a weak table
or an inclined or unstable location. The
weight of the main body is approx. 25 kg.
The temperature should be between 10C
and 35C and the relative humidity should
be between 20% and 80%. However,
since the performance is guaranteed at a
temperature between 15C and 27.5C
and a relative humidity between 25% and
75%, this machine should be installed in
this range.
The power supply must be able to be con-
nected separately from a reference volt-
age receptacle.
If a ground wire must be connected, con-
nect it to the correct location shown below.
1) Ground terminal of the receptacle.
2) Ground wire for which grounding work for
office equipment is performed.
CANON DR-G2140/G2110/G2090 FIRST EDITION
CHAPTER 4 INSTALLATION & MAINTENANCE
4-1