Attaching Deck Pressure Plate; Setting Toner Container - Canon iR5055 Series Service Manual

2) Pull out the right deck and cassette 3/4 halfway. Open the lower right cov-
er and remove the pickup roller pressure release spacers [1].
MEMO:
When the deck and cassette are stored, the spacer is pressured and hard to
remove. Thus, pull put the deck and cassette halfway to release the
pressure.
3) After removing each spacer, close the deck, cassette and lower right cover.
4) Attach the door tape of the upper right cover with the screw, and close the
upper right cover.

2.2.8 Attaching Deck Pressure Plate

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
1) Press the release button of the left deck and slide the left deck out.
2) Attach the deck pressure plate [1] with the screw (RS tightening; M4X8)
[2].
[1]
3) Close the left deck.

2.2.9 Setting Toner Container

iR5065 / iR 5055 / iR5075 / iR5075N / iR5065N / iR5055N
[1]
F-2-34
[1]
F-2-35
[2]
F-2-36
Do not shake the toner container.
If setting the toner container that has been shaken to the host machine, the
toner overflow within the machine may occur.
By shaking the container, the toner fluidity increases. As a result, toner is
supplied swiftly to the machine with the toner supply operation, causing the
foregoing symptoms.
1) Take out the toner container from the packing box.
2) After opening the toner replacement cover [1], pull down the lock lever
[2] in the direction of the arrow.
3) Hold the toner container [1] as shown in the figure below, and remove the
cap [2] from the container by rotating the cap in the direction of the arrow.
0015-4663
4) Hold the toner container with its mouth [1] at the right side, and set it into
the supply case [2] of the host machine horizontally.
0015-4664
5) Slide the lock lever [1] upward to lock the toner container [2] in place.
[1] [2]
F-2-37
[2]
[1]
F-2-38
[2]
[1]
F-2-39
Chapter 2
2-11