CHAPTER 14
Connecting, Grounding, and Powering On
the Services Gateway
Connecting the SRX210 Services Gateway to the Power Supply
Copyright © 2012, Juniper Networks, Inc.
Connecting the SRX210 Services Gateway to the Power Supply on page 105
Connecting and Organizing Interface Cables for the SRX210 Services
Gateway on page 106
Grounding the SRX210 Services Gateway on page 108
Powering On and Powering Off the SRX210 Services Gateway on page 109
To connect the device to the power supply:
CAUTION:
Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE:
If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
Plug the DC connector end of the power cable into the power connector on the back
1.
of the device (see
Figure 24 on page
Plug the AC adapter end of the power cable into an AC power outlet.
2.
106).
105